-
Slope stabilization – stack 2 gabions
Over a period of a few weeks, I built the first row of gabions over a length of around 30 meters. A relatively straight section was followed by a slight bend. By placing the gabions inside each other, I was able to form a corner on the south-east side. Towards the end, the difference in height to the existing gabion wall was evened out using a gabion terrace.
-
Securing slopes with gabions – installing stones correctly
I had now erected the first row of gabions on my earth slope over a length of a good 30 meters. I drew a nice curve for the next 20 meters and then built a real corner with a height offset for the remaining meters. Before I could install the second row of stone baskets, the bottom row first had to be filled with stones.
-
Securing slopes with gabions – building corners and curves
The stone baskets for the gabion wall were erected over a length of a good 20 meters within a few weeks. Starting from the driveway in a south-easterly direction, I was able to build a slight curve. The spirals provide a certain amount of play – but this does not allow for tight curves. So now I had to form proper corners with
-
Slope stabilization with gabions – Building raised beds with gabions
Below the gabion-enclosed parking lot, right next to the house, there is an earth slope. This is a good 6m long and just under 2m deep. The entire terrain is sloping at this point and the slope compensates for a height difference of around 1.5m. The slope is so steep that it slides downwards bit by bit during heavy rainfall. I had to find a solution for slope stabilization quickly.
-
Securing a slope with gabions – fleece water conduits
Over the last few weeks, I have now removed the plateau and rebuilt the slope. The gabions were also set up and aligned. However, further preparations are required before backfilling can begin.
-
Securing a 30-meter slope with gabions – setting up and aligning the stone baskets
After I had removed the earth slope the previous week and the subsoil had also been largely removed, I was able to start assembling and placing the gabions.